HEIDENHAIN TNC 426 PB/M Technical Manual page 56

2 – 46
n
With MP6500 bit 4 you can define whether speed should be limited to
1000 rpm during tool measurement with TT.
n
MP6500 bit 9: Automatic determination of the basic rotation for tool
measurement with the cubical probe contact
n
W760: Angular misalignment of the tilting axes for automatic adjustment of
touch probe center misalignment
n
The calibration data of the TS can be saved in the tool table by soft key.
n
Cycle 31 to 33 (tool measurement) were expanded by the input field "Q
parameter for result."
n
With MP6500 bit 5 and bit 6 you can define the reaction to tool breakage.
n
FN17, FN18 ID990 NR1 behavior during programmed probing
n
FN17: ID210 NR6 Tilting the working plane during program run
active/inactive
n
FN17: ID50 Overwrite tool table
n
FN17: ID210 Overwrite basic rotation
n
FN18 ID350 Extended touch probe data
n
FN23: CDATA Calculating the circle center from three probe points
n
FN24: CDATA Calculating the circle center from four probe points
n
FN25: Setting the datum
n
ISO: Cycles with numbers greater than 200 can be programmed with
graphic support (also OEM cycles)
n
ISO: Cycles G75 and G76 (rectangular pocket) now include an input box for
corner radius
n
ISO: Parameter H (limit angle) can be entered after M112
n
ISO: G60 Running digitized data new
n
MP2000 removed. Digital axes can be defined in MP120
n
In the compensation value tables COM and CMA you select the columns for
the desired axes with soft keys.
n
Nonlinear axis-error compensation: maximum number of compensation
points increased from 640 to 1280
n
A formula can be entered in MP2020 (distance per motor revolution).
n
MP2541, MP2451: Band filter for spindle
n
The number of tools in the tool table was increased from 254 to 32 767.
n
M4019: Reversing the counting direction of the position encoder on the
spindle
n
Cooperative multitasking in the PLC (SPAWN command)
n
Automatic tool recognition (BIS)
n
String operand S#Axx new
n
Module 9019: Check program stack
n
Module 9035: Expanded by parameters 3, 1000, 1001
n
Module 9038: Read axis information
n
Module 9096: Erasing a line in the tool table
n
Module 9112: Transmitting ASCII characters via RS-232-C
n
Module 9113: Receiving ASCII characters via RS-232-C
n
Module 9151: Select traverse range and axis designation
HEIDENHAIN Technical Manual TNC 426, TNC 430