HEIDENHAIN TNC 426 PB/M Technical Manual page 59

NC software
280 472-08 (export
version 280 473-08)
NC software
280 472-09 (export
version 280 473-09)
NC software
280 472-10 (export
version 280 473-10)
NC software
280 472-11 (export
version 280 473-11)
NC software
280 472-12 (export
version 280 473-12)
December 2001
Release: 07/98
Improvements:
n
MP2510 and MP2511: Maximum input value reduced to 30 000
n
MP2191: Decelerating spindle at EMERGENCY STOP
n
MP6161: M function for orienting infrared probe before measurement
n
MP6162: Orientation angle
n
MP6163: Minimum difference before executing an oriented spindle stop
n
New strings S4 to S7
n
FN17 ID50: Overwrite data in tool table
n
FN17 ID420: Effectiveness of cycles 7, 8, 10, 11, 26 and 19
n
Module 9032: "No system memory" error code
n
Module 9071, 9082, 9210: Transfer of an immediate string
n
"Shut down" soft key to shut down the control
n
Automatic tool compensation with the touch-probe cycles 421 to 426
n
ISO: With G36 (spindle orientation) it is possible to program a Q parameter
as an angular value.
Release: 10/98
Improvements:
n
MP6500 bit 13: Tilted system in which the tool is measured
n
Module 9210: Path and name of the screen mask as an immediate string
n
Cycle 420: Determine angle in the touch probe axis
n
Cycle 427: Automatic length and radius compensation
Release: 11/98
Improvements:
n
The version of the setup disks is also displayed via the MOD key.
Release: 11/98
Improvements:
n
MP334: Number of grating periods between the zero pulses on encoders
with distance-coded reference marks
Release: 12/98
Improvements:
n
Cycle 201, 202, 203: The default value in Q208 was increased to 30 000 mm
or 1200 inches
n
Cycle 212, 214: The contour is approached at the programmed machining
feed rate
n
Cycle 210, 211: The starting point for the finishing cut is approached at the
machining feed rate
n
Cycle 421, 422: A basic rotation or a rotation via cycle 10 is considered for
the probing direction
Software Releases 2 – 49