Table of Contents
Advertisement
December 2001
n
New timers T96 to T143
n
New strings S4 to S7
n
W266: Index number of a programmed indexed tool
n
D604: Maximum possible spindle speed
n
Module 9008: Read certain inputs of PLC input/output unit
n
Module 9009: Set certain outputs of PLC input/output unit
n
Module 9088: Display M functions in status window
n
Module 9091: Determine line number of tool in tool table
n
Module 9145: Automatic actual and nominal value transfer
n
Module 9175: Activate spindle
n
Module 9202: A PLC window can be activated if the table editor is active
n
Two spindles can be operated alternately
n
The active M functions can be displayed with the STATUS M FUNCT. soft
key.
n
Indexed tools can be entered
n
Program sections can be marked, deleted and copied in the NC editor
n
ISO: Tool offsets can be entered when the tool number is programmed
n
With M128 a feed rate can be entered for the maximum speed of the
compensation traverse for the linear axes
n
Cycle 205: Universal pecking
n
Cycle 206: Tapping
n
Cycle 207: Rigid tapping
n
Cycle 208: Helical finish milling
n
Cycle 200: Dwell time at bottom of hole
n
Cycle 203: Retraction path at chip breaking
n
Cycle 220: Approach clearance height during machining
n
Cycle 210, 211, 212, 213, 214, 215, 220, 221: Preposition with positioning
logic
n
Cycle 410 to 418: Set datum not equal to zero
Software Releases
2 – 53
Advertisement
Table of Contents
