General Information; Important Safety Warnings; Copyright; Product Names And Trademarks - Danfoss VLT ISD Connection Box Operating Instructions Manual

General Information

1 General Information

1.1 Important Safety Warnings

WARNING
HIGH VOLTAGE
The ISD 410 servo system contains components which
operate at a high voltage when connected to the electrical
supply network. A hazardous voltage is present on the
servomotors, the power supply module and the
connection box whenever they are connected to the mains
network. There are no indicators on the servomotor that
indicate the presence of mains voltage. This indication is
provided on the connection box. Installation, commis-
sioning and maintenance may only be performed by
qualified personnel. Incorrect installation, commissioning or
maintenance can lead to death or serious injury.
WARNING
UNINTENDED START
The ISD 410 servo system contains servomotors which are
connected to the electrical supply network and can start
running at any time. This may be caused by an external
switch, a CAN bus command, a reference signal, or clearing
a fault condition. Servomotors and all connected devices
must be in good operating condition. A deficient operating
condition may lead to death, serious injury, damage to
equipment or other material damage when the unit is
connected to the electrical supply network. Take suitable
measures to prevent unintended starts.
WARNING
DISCHARGE TIME
The servomotors, the connection box and the power
supply module contain DC link capacitors, that remain
charged for some time after the mains supply is switched
off at the power supply module.
To avoid electrical shock, fully disconnect the power
supply module from the mains before carrying out any
maintenance on the ISD servo system or its components.
Wait for at least the time listed below before carrying out
maintenance work:
Number Minimum waiting time (discharge time)
0-60 servomotors 10 minutes
Note: High voltage may still be present even if the LED on the
ISD connection box is not lit!
Table 1.1 Discharge Time
®
VLT ISD Connection Box Operating Instructions

1.2 Copyright

Disclosure, duplication and sale of this document, as well
as communication of its content, are prohibited unless
explicitly permitted. Infringement of this prohibition incurs
liability for damages. All rights reserved with regard to
patents, utility patents and registered designs.
ISD is a registered trademark.

1.3 Product Names and Trademarks

VLT
other product names and trademarks used in this
documentation are trademarks or registered trademarks of
their respective titleholders.

1.4 Disclaimer

No liability is assumed for any damage or breakdown
resulting from:

1.5 Approvals

1.5.1 ISD 410 Servomotor, ISD Encoder Box
Table 1.2 Approvals for the ISD 410 Servomotor, ISD Encoder Box
and ISD Connection Box
®
MG75G102 - VLT is a registered Danfoss trademark
® ®
and ISD are registered trademarks of Danfoss. All
•
Failure to observe the information in the
instruction manuals
•
Unauthorised modifications to the ISD servo
system or its components
•
Operator error
•
Improper work on or with the ISD servo system
or its components.
and ISD Connection Box
1 1
5