Intended Use; Foreseeable Misuse - Danfoss VLT ISD Connection Box Operating Instructions Manual

Safety instructions

3.6 Intended Use

The components of the ISD servo system are intended to
be installed in machines used in commercial and industrial
3 3
environments.
To ensure that the product is used as intended, the
following conditions must be fulfilled before use:
•
everyone who uses Danfoss products in any
manner must read and understand the
corresponding safety regulations and the
description of the intended use.
•
hardware must be left in its original state, which
means that no structural changes may be made
to the hardware.
•
software products may not be reverse-engineered
and their source code may not be altered.
•
damaged or faulty products may not be installed
or put into service.
•
it must be ensured that the products are installed
in conformance with the regulations mentioned
in the documentation.
•
any specified maintenance and service intervals
must be observed.
•
all protective measures must be complied with
•
only the components described in these
operating instructions may be fitted or installed.
Third-party devices and equipment may be used
only in consultation with Danfoss
•
the documentation must be read completely and
correctly followed
The servo system may not be used in the following
application areas:
•
areas with potentially explosive atmospheres
•
mobile or portable systems
•
floating or airborne systems
•
inhabited facilities
•
sites where radioactive materials are present
•
areas with extreme temperature variations or in
which the maximum rated temperatures may be
exceeded
•
under water
12
®
VLT ISD Connection Box Operating Instructions

3.7 Foreseeable Misuse

Any use not expressly approved by Danfoss constitutes
misuse. This also applies to failure to comply with the
specified operating conditions and applications.
Danfoss assumes no liability of any sort for damage attrib-
utable to improper use.
®
MG75G102 - VLT is a registered Danfoss trademark