Setting The Coin And Credit Configuration - Simuline Cycraft Installation & User Manual

LED Normal
¨
LED Driving
¨
LED Error
¨
LED Safety
¨
LED Seatbelt
¨
Buzzer
¨
6.5.5 MOTION TEST
This menu item runs the motion system of Cycraft through a series of pre-recorded
slow speed motion. It can be used to verify that the actuators are operating properly.
After finishing the test, you should press the shutdown SW to finalizing the test.
6.5.6 MOTION LEVEL
This is only use for Simuline. Default factory set is 1. Do not change the value without
request from Simuline.
6.5.7 FALLING DETECT
This is only use for Simuline. Default factory set is 2. Do not change the value without
request from Simuline.

6.6 SETTING THE COIN AND CREDIT CONFIGURATION

The coin and credit configuration (i.e. cost per game) must be set directly on the game
computer (NAOMI2) by using the "Service" and "Test" buttons on the Operator Panel.
Refer to the NAOMI2 service manual for instruction on how to change the coin and
credit configuration.
Page 54