Getting Started - Sartorius Talent Operating Instructions Manual

Getting Started

Storage and Shipping Conditions
– Do not expose the balance/scale to
extreme temperatures, blows, shocks,
vibration or moisture.
Unpacking the Balance/Scale
G After unpacking the balance/scale,
check it immediately for any visible
damage.
$ If you see any sign of damage, proceed
as directed in the chapter entitled "Care
and Maintenance," under the section on
"Safety Inspection".
$ Save the box and all parts of the
packaging until you have successfully
installed your balance/scale in case you
need to return it. Before packing your
balance/scale, unplug all connected
cables to prevent damage.
Equipment Supplied
– Balance/scale
– Weighing pan
– Pan support (only on models with
a round weighing pan)
– Gem tray (only with GE and GD models)
– AC adapter, plug type
Additionally supplied with TE214S,
TE124S, TE64, GD603 models:
– Shield ring
– Shield plate
– Dust cover
– Calibration weight
4
Installation Instructions
When choosing a location to set up
your balance/scale, observe the
following:
– Avoid placing the balance/scale in
close proximity to a heater or otherwise
exposing the balance/scale to heat or
direct sunlight
– Protect the balance/scale from drafts
that come from open windows or doors
– Avoid exposing the balance/scale to
extreme vibrations during weighing
– Do not expose the balance/scale to
extreme moisture over long periods
Conditioning the Balance/Scale
Moisture in the air can condense
on the surfaces of a cold balance/scale
whenever it is brought into a substan-
tially warmer place.
If you transfer the balance/scale to
a warmer area, make sure to condition it
for about 2 hours at room temperature,
leaving it unplugged from AC power.
Seal on Balances/Scales of Accuracy
Class K and l :
Legislation requires that a control seal
be affixed to verified balances/scales
of accuracy class K or l . The control
seal consists of a sticker with the
"Sartorius" logo. If this seal is damaged
or broken, the verification becomes null
and void and the balance/scale must be
re-verified.