Initial Verification - Sartorius Talent Operating Instructions Manual

Initial Verification

TE1200-0CE Models:
These models are supplied for use
in legal metrology (legal-for-trade) in
Germany and already verified ex factory.
For use in legal metrology outside
Germany, the balances/scales must be
initially verified for the respective
country at the place of installation.
In such a case, please contact your
Sartorius representative about the
verification procedure.
TE214S-0CE, TE214S-PCE,
TE124S-0CE, TE64-0CE and
GD603-0CE Models:
These models are verified ex factory for
use in the legal metrology within the
European Economic Area upon delivery.
You can use the balance/scale immedi-
ately after:
– Warming up phase (see page 7)
– Adjustment (see page 8)
Always calibrate/adjust the balance/
scale with the weight supplied at
regular intervals and after setting it
up in a new location.
TE512-0CE, TE512-PCE and
GE512-0CE Models
These models are verified ex factory for
use in legal metrology within the Euro-
pean Economic Area upon delivery.
§ Before using the balance/scale as a legal
measuring instrument, calibrate and
adjust it at the place of use using the
built-in motorized calibration weight;
for details, see "Calibration/Adjustment."
$ The temperature range (°C) indicated
on the verification label may not be
exceeded during operation.
Example:
DT BH 210
+10°C/+30°C
K
Using Verified Balances/Scales as Legal
Measuring Instruments in the EU*:
The type-approval certificate for verifi-
cation applies only to non-automatic
weighing instruments. For automatic
operation with or without auxiliary
measuring devices, you must comply
with the regulations applicable to the
place of installation.
* Including the Signatories of the Agree-
ment on the European Economic Area
3