Sargent Profile Series v.S2 Installation Instructions Manual page 11

Step #5 – Install Gasket (for Exterior Doors)
For exterior applications, use weather seal gasket between escutcheon
and outside door surface. To apply weatherseal gasket:
1. Carefully remove the backing from the gasket. (Fig. 5A).
2. Apply gasket to escutcheon:
a. Starting in one place, press the adhesive side
of the gasket firmly against the escutcheon.
b. Work around the escutcheon, pressing the
sticky side of the gasket firmly against the
escutcheon edge.
c. The gasket should be aligned so that all edges
of the escutcheon are covered.
3. Attach escutcheon to the door.
Note: The 43 cylinder may be used with or without a gasket.
Step #6 – Install Gasket (for Exterior Doors)
1A. For fire rated doors:
from outside of door through weatherseal gasket and fire stop plate (Fig. 6A).
Note: Install ribbon cable with cable exiting down
1B. For non-fire rated doors:
wire from outside of door through weatherseal gasket (if used)
and weather conduit (Fig. 6B).
Note: Install ribbon cable with cable exiting down
2. With outside lever horizontal, locate the outside escutcheon on the door,
while directing the mounting posts through the door and lock body (Fig. 6B).
Make sure the lever spindle is properly engaged in lock.
7. On the inside of the door, insert spindle into square hole
of mortise lock.
8. Slide inside adapter and plate
assembly over spindle and loosely
secure with 2 through -bolt
screws (#8-32 x 5/8").
Note: For 8276 and 8278,
loosely thread cylinder
through escutcheon
and into the lock body
before tightening the
lock case screws
and escutcheon
through bolts.
10 1-800-810-WIRE • www.sargentlock.com • A7786E
feed ribbon cable with connector and ground wire
feed ribbon cable with connector and ground
Reader
Cable
Antenna
(iCLASS)
Ground
Wire (E1)
Mortise Lock body
and AX Connectors
Fig. 6B
Inside of Door
Profile Series v.S2 WiFi Mortise Lock
Fig. 5A
Antenna
(iCLASS
only)
Outside of Door
Gasket
Keypad
Ribbon
Cable
Antenna
(iCLASS)
Only
Ground
Wire
(E1)
Fig. 5B
Ground
Wire (E1)
Keypad
Ribbon
Cable
Fig. 6A