Sargent Profile Series v.S2 Installation Instructions Manual page 14

Profile Series v.S2 WiFi Mortise Lock
Step #11 – Install and Secure Cylinder
1. Slide cylinder through the spring and rosette/collar
and screw into lockbody, rotating the cylinder
clockwise (Fig. 11A).
Cylinder should be flush with escutcheon.
Note: The 43 cylinder may be used when installing
this product with or without a gasket.
Note: SARGENT logo must be horizontal and
on the top of the cylinder (Fig. 11B).
2. Secure the cylinder by tightening cylinder clamp
screw located above the deadbolt using #2
Phillips screwdriver (Fig. 11C).
3. Using the key, test cylinder functions:
• 8278 Function: Key retracts latch.
• 8276 Function: Key retracts latch and projects
and retracts deadbolt.
Cylinder Clamp Screw
#2 Phillips
Screwdriver
Step #12 – Attach Front Plate
Attach front plate with (2) flat head screws.
Outside of Door
Fig. 11C
Front Plate
(2) Flat Head Screws
1-800-810-WIRE • www.sargentlock.com • A7786E
Outside of Door
Type 43 Cylinder
Fig. 11A
Position cylinder so that the
SARGENT logo is right-side up.
Correct Incorrect
Fig. 11B
Outside of Door
Lock body Screws
Fig. 12A
Key
13