Assembly; Fitting The Main Body; Assembling The Handlebar And Throttle; Connecting Throttle Cable And Stop Switch Wires - Husqvarna 226R Operator's Manual

Fitting the main body

Connect the engine (A) to the tube (B) with three screws
(C).
B C
Assembling the handlebar and
throttle
• Fit the handlebar in the handlebar clamp on the shaft
using four screws.
Fit the protective sleeve as shown in the diagram.
72 – English

ASSEMBLY

A
Connecting throttle cable and
stop switch wires
1 Remove the air filter cover.
2 Insert the throttle cable (A) through the carburettor
bracket (B), then screw the cable adjuster sleeve (C)
into the carburettor bracket fully.
3 Position the slotted fitting (D) on the carburettor so the
recessed hole (E) for the cable lug (F) is away from the
cable adjuster sleeve.
4 Rotate the carburettor throttle cam and slip the throttle
cable through the slot in the slotted fitting, making
sure the cable lug drops into the recessed hole.
5 Operate the throttle trigger a few times to make sure
that it works correctly.
6 Adjust the cable adjuster sleeve so the stop on the
carburettor throttle cam just contacts the throttle stop
and the cable position keep 1-2 mm play between the
cable lug and the slotted fitting when the throttle
trigger is fully depressed.
1-2mm
7 When the throttle cable is adjusted correctly, tighten
the locking nut (G).