Meter Instructions; Power Up; Key Function - Insportline Yukona User Manual

METER INSTRUCTIONS

POWER UP


Connect all the cables to the monitor.

After powering up, all LCD segments will light up for 2 seconds and CPU will be reset the
resistance to level 1. The monitor will enter the initial mode.

If the connection cables are installed incorrectly, the motor will not work. Before contacting
service: Check the cable connection and then reset the power to release a beep sound or
press START/STOP key. Hold it to reset the device and to restart the system. If the motor still
doesn't work, contact authorized service.

KEY FUNCTION

START/STOP
FUN/SCAN
PROG/RESET

Key combination: FUN/SCAN and simultaneously UP (+) button for 3 seconds – motor
introspection.

Key combination: at the same time PROGRAM and DOWN (-) button for 3 seconds – ODO
values examination.

To start or pause the workout.

Under stop condition, push it to enter parameter setting.

Confirm set values of the parameters and go into next setting.

In the start state, push it to display fixed current parameter values.
Push it to switch into automatic scanning function and parameter
displaying.

In parameter setting, push it to increase the value.

In start state, push it to increase the resistance.

In parameter setting, push it to decrease the value.

In start state, push it to decrease the resistance.

In stop state, push it to select required movement patterns.

In any state push it long (for 5 seconds) and the electronic watch
resets. All the data, except ODO will be reset.
14