Identification Labels; Receiving And Storage - WEG MW500 User Manual

General Information

2.4 IDENTIFICATION LABELS

There are two identification labels: one complete nameplate, located on the side of the inverter
and other simplified label inside the inverter shown in
label over the plug-in module allows the identification of the most important characteristics of
the inverter. For further details about the position of the labels, see
and Figure A.3 on page 124
MW500 model
WEG part number
Rated input data (voltage,
current and frequency)
MW500 model
WEG part number
Serial number
Figure 2.2: (a) and (b) Description of the identification labels series MW500

2.5 RECEIVING AND STORAGE

The MW500 is supplied packed in a cardboard box. On this package, there is an identification
label which is the same as the one attached to the side of the inverter.
Check if:
The identification of the MW500 matches the model purchased.
„
Any damages occurred during transportation.
„
Report any damage immediately to the carrier.
6 | MW500
of APPENDIX A - PARTS on page
(a) Side label of the MW500
(b) Simplified internal label (over the plug-in module)
Figure 2.2 on page 6. The simplified
Figure A.2 on page 123
122.
Serial number
Manufacturing date
Rated output data
(voltage, current and
frequency)
Manufacturing date