Nomenclature - WEG MW500 User Manual

2.3 NOMENCLATURE

Identification of the Model
Rated
Frame
Current
Eg.: MW500 B 06P5
See Table 2.2 on page 5
DB = with dynamic braking
MW500
66 = IP66/Nema4X (degree of protection)
Table 2.2: Available options for each field of the nomenclature according to the rated current and voltage of the inverter
Rated Output
N° of Phases Rated Voltage
Current
S = single-
04P3 = 4.3 A
phase power
06P0 = 6.0 A
supply
A
T = three-
02P6 = 2.6 A
phase power
04P3 = 4.3 A
supply
T = three-
06P5 = 6.5 A
B phase power
10P0 = 10.0 A
supply
T = three-
14P0
C phase power
16P0
supply
Table 2.1: Nomenclature of the MW500 inverters
N° of Rated
Phases Voltage
T 4 DB 66
Available Options for the Remaining Identification Codes of
Degree of
Protection
2 = 200...240 V
4 = 380...480 V
DB
4 = 380...480 V
4 = 380...480 V
General Information
C2 DS A56
A56 = motor
connection
box size
56 x 56 mm;
this applies
only to the
frame sizes A
and B
A70 = motor
connection
box size
70 x 70 mm;
this applies
only to the
frame sizes A
and B
Blank =
motor
connection
box size
70 x 70 mm
and 110 x
110 mm; this
applies only
to the frame
size C
DS = with disconnecting switch
Blank = without disconnecting switch
Blank = It does not meet the standards leves for
conducted emission
C2 = with internal RFI filter
the Inverters
Conducted Disconnecting
Emission Level
66 Blank or C2 Blank or DS
--- --
Blank =
standard
Sx = special
software
Blank = standard
plug-in module
H00 = without
plug-in
Connection
Switch Box
A56 or A70
MW500 | 5