Motor And Adaptation Kit Selection; Electrical Installation; Identification Of The Power Terminals And Grounding Points - WEG MW500 User Manual

ATTENTION!
Provide independent conduits for the physical separation of signal, control, and
power cables (refer to

3.1.3 Motor and Adaptation Kit Selection

To select the compatible motor frame:
See Table C.1 on page 134
page 134.
To select adaptation kits:
See Table C.2 on page 135
page 134.
NOTE!
In order to install the MW500 on the motor, it is recommended to use the
terminals supplied with the inverter. (See
ATTENTION!
In case the MW500 Frame A is installed on a WEG motor W22 frame 112,
„
182/T4 and 213/5T the terminals supplied with the motor cannot be used.
If the MW500 is installed on a motor that is not of the WEG W22 line, the use
„
of the terminals must be checked.
Always check the tightening torque of the motor terminal connections
„
(Example: 2 Nm).

3.2 ELECTRICAL INSTALLATION

DANGER!
The following information is merely a guide for proper installation. Comply
„
with the applicable local regulations for electrical installations.
Make sure the power supply is disconnected before starting the installation.
„
The MW500 must not be used as an emergency stop device. Provide other
„
devices for that purpose.

3.2.1 Identification of the Power Terminals and Grounding Points

The location of the power, grounding and control connections are shown in
page 123.
Section 3.2 ELECTRICAL INSTALLATION on page
of APPENDIX C - MOTOR FRAME AND ADAPTATION KITS on
of APPENDIX C - MOTOR FRAME AND ADAPTATION KITS on
Installation and Connection
Table C.1 on page 134)
9).
Figure A.2 on
MW500 | 9