Opel Zafira B MPV 2006 Owners Workshop Manual page 85

of the new retaining bolt threads then offer
up the flywheel, if the original is being refitted
align the marks made prior to removal. Screw
in the retaining bolts.
1 O Lock the flywheel by the method used on
removal, and tighten the retaining bolts to the
specified Stage 1 torque setting then
angle-tighten the bolts through the specified
Stage 2 angle, using a socket and extension
bar, and finally through the specified Stage 3
angle. It is recommended that an angle-
measuring gauge is used during the final
stages of the tightening, to ensure accuracy. If
a gauge is not available, use white paint to
make alignment marks between the bolt head
and flywheel prior to tightening; the marks can
then be used to check that the bolt has been
rotated through the correct angle.
2.2 litre petrol engine in-car repair procedures 28•17
11
Refit the clutch as described in Chapter 6
then remove the locking tool, and refit the
transmission as described in Chapter 7 A.
Automatic transmission models
12 Clean the mating surfaces of the driveplate
and crankshaft and remove all traces of locking
compound from the driveplate retaining bolt
threads.
13 Apply a drop of locking compound to each
of the new retaining bolt threads then offer up
the driveplate, if the original is being refitted
align the marks made prior to removal. Screw
in the retaining bolts.
14 Lock the driveplate by the method used
on removal, and tighten the retaining bolts
to the specified Stage 1 torque setting then
angle-tighten the bolts through the specified
Stage 2 angle, using a socket and extension
bar. It is recommended that an angle-
measuring gauge is used during the final
stages of the tightening, to ensure accuracy.
If a gauge is not available, use white paint to
make alignment marks between the bolt head
and flywheel prior
to
tightening; the marks can
then be used to check that the bolt has been
rotated through the correct angle.
15 Remove the locking tool and refit the
transmission as described in Chapter 78.
11 Sn~eltransmission
. mountings ...
i~pectioo ·arid .renewal
Refer to Chapter 2A, Section 19.