Door Handles And Lock Components; Door Interior Handle; Front Door Exterior Handle; Prise Bottom/Ides Of Panel Away From Door To Release Internal Clips - Opel Zafira B MPV 2006 Owners Workshop Manual

11 •8 Bodywork and fittings
12.3 Carefully prise off the tweeter
speaker trim panel, complete with speaker
12.5 Carefully prise the bottom and sides
of the panel away from door to release the
internal clips
4 Undo the tower screw and the rear screw
securing the edge of the trim panel to the door
(see illustrations).
5 Using a wide-bladed screwdriver or removal
toot, carefully prise the bottom and sides of the
panel away from door to release the internal
clips (see illustration). Lift the panel upward
to release it from the window aperture.
6 Once the panel is free, reach behind and
release the door lock operating cable from the
interior handle. Disengage the inner cable end
from the handle lever (see illustration).
7 Disconnect the wiring connectors from
the window control switch and door interior
handle, then remove the trim panel from the
car (see illustrations).
Refitting
8 Refitting is a reversal of removal.
12.7a Disconnect the wiring connectors
from the window control switch ...
12.4a Undo the lower screw •••
12.6 Reach behind the panel and release
the door lock operating cable from the
interior handle
Rear door
Removal
9 Where a manual window regulator is fitted,
locate a cloth rag between the handle and the
trim panel and pull it to one side to release
the spring clip. Remove the handle from the
splined shaft and refit the spring clip to the
handle.
10 Using a plastic wedge or similar tool,
carefully prise off the door grab handle plastic
cover and undo the two screws now exposed
(see illustrations 12.1a and 12.1b}.
11 Pull open the door interior handle and prise
off the trim plate using a small screwdriver.
Undo the screw in the trim panel aperture (see
illustrations 12.2a and 12.2b).
12 Using a wide-bladed screwdriver or removal
tool, carefully prise the bottom and sides of the
12.7b ••• and door interior handle
12.4b ... and the rear screw securing the
edge of the trim panel to the door
panel away from door to release the internal
clips. Lift the panel upward to release it from
the window aperture (see illustration).
13 Once the panel is free, reach behind and
release the door lock operating cable from the
interior handle. Disengage the inner cable end
from the handle lever (see illustration 12.6).
14 On models with electric windows,
disconnect the wiring connector from the
window control switch, then remove the trim
panel from the car.
Refitting
15 Refitting is a reversal of removal.
11 Doo'r h~ntiles
SJld<f()~k eomponents -
· · flll()Val. and refitting
Door interior handle
Removal
1 The door interior handle is an integral part
of the door inner trim panel and cannot be
individually removed. If there are any problems
with the interior handle, a new inner trim panel
will be required.
Front door exterior handle
Removal
2 On vehicles with the Open and Start system,
remove the door inner trim panel as described
in Section 12, and disconnect the Open and
Start wiring harness connector.
12.12 Carefully prise the bottom and sides
of the panel away from door to release the
internal clips