Replace Steering Wheel; Remove; Install - Taylor-Dunn B5-540-48XL Service And Replacement Parts Manual

B5-440-36 / B5-440-48 / B5-540-48XL / BF-030-48

REPLACE STEERING WHEEL

WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
Note: The steering wheel is on a tapered shaft and may be damaged when it is removed.

Remove

1: Remove the steering wheel hub cover.
2: Remove the steering wheel nut.
3: Using a steering wheel puller, remove the steering wheel.

Install

1: Check wheel alignment before installing steering wheel.
2: Position the front wheels in the straight ahead position.
3: Lightly grease the steering wheel splines and install the
replacement steering wheel orientated as shown in the
illustration.
4: Tighten the steering wheel nut to torque listed in the
Hardware Torque table at the end of this section.
5: Reinstall the horn switch (if equipped).
6: Reconnect the main positive and negative cables at the
batteries.
7: Remove the blocks from behind the wheels.
8: Release the parking brake and test drive.
MB-440-06
Steering
Page 61