Comtech EF Data Radyne RCS20 Installation And Operation Manual page 68

RCS20 M:N Redundancy Switch
User Interfaces
4.3.2.7 REMOTE PORT ADDRESS
This subscreen allows the user to modify the RCS20 remote port baud address.
4.3.2.7.1 Programming steps:
1. Use the numeric keypad to enter the desired multi-drop address for the RCS20. Valid addresses
are 32 through 255.
2. Press <CLR> or <NEXT> to abort programming (no switch parameters changed).
3. Press <ENT> to load the information on the screen into the switch parameter table. Switching will
occur immediately after pressing <ENT>.
Key Label
S1 ---
S2 ---
S3 ---
S4 RETURN
Numeric Keypad ---
REMOTE PORT ADDRESS :
N/A
N/A
N/A
Press to select the value entered on the keypad and cycle back to the TERMINAL
PORT CONFIGURATION Screen
Use the numeric keypad to enter the desired multi-drop address for the RCS20. Valid
addresses are 32 through 255.
Press <CLR> or <NEXT> to abort programming (no switch parameters changed).
Press <ENT> to load the information on the screen into the switch parameter table.
Switching will occur immediately after pressing <ENT>.
4–36
32
RETURN
Function
Revision 15
MN-RCS20 and CD-RCS20