Table of Contents
Advertisement
RCS20 M:N Redundancy Switch
User Interfaces
4.3.1.18 COPY MODEM CONFIGURATION
This screen allows the user to copy configurations between (from/to) modems.
Key
S1
S2
S3
S4
Numeric Keypad
4.3.1.19 MOD FAULT DELAY
This screen allows the user to program the modulator fault delays (in seconds) for each prime channel on
the RCS20. The fault delays for a modulator are used to debounce the modulator faults, thus if a
modulator fails, a timer is started and the failure will not be recognized by the RCS20 until the timer
COPY MODEM CONFIGURATION
<ENT> to accept, <CLR> to abort.
COPY FROM :
COPY TO
:
CURSOR
UP
Label
CURSOR
Press to toggle between COPY FROM and COPY TO.
Press to cycle up through the modems in the line selected by
UP
pressing S1 (MODEM1 - MODEM9).
Press to cycle down through the modems in the line selected by
DOWN
pressing S1 (MODEM9 - MODEM1).
Press to cycle back to the LEARN/BACKUP TEST
CANCEL
CONFIGURATION Screen.
Press <ENT> to accept the selection from S1, S2, and S3.
---
Press <CLR> to abort changes and cycle back to the
LEARN/BACKUP TEST CONFIGURATION Screen.
MOD FAULT DELAY (SECONDS)
MOD
:MOD1
MOD2
MOD3
0.5
0.5
MOD6
MOD7
0.5
0.5
<---
--->
4–24
MODEM1
MODEM8
DOWN
CANCEL
Function
USE KEYPAD
MOD4
Mod5
0.5
1.0
0.5
MOD8
MOD9
0.5
0.5
NEXT
Revision 15
MN-RCS20 and CD-RCS20
Advertisement
Table of Contents
