Config System Menu Tree - Comtech EF Data Radyne RCS20 Installation And Operation Manual

RCS20 M:N Redundancy Switch
User Interfaces
Key Label
S3 ---
S4 RETURN
Numeric Keypad ---

4.3.2 CONFIG SYSTEM Menu Tree

4.3.2.1 CONTROL MODE CONFIGURATION
This screen allows the user to modify the control mode. The Control Mode may be one of the following:
FT PANEL - Front Panel Control - Commands will only be accepted from the front panel and
•
keypad.
TERM - Remote Terminal Control - Commands will only be accepted through the RS-232
•
terminal connection.
COMPUTER - Command Interface Control - Commands will only be accepted from the RS-484
•
remote port connection.
4.3.2.1.1 Programming steps:
1. Press <FT PANEL>, <TERM>, or <COMPUTER> to select the desired control mode. The mode
will be selected immediately after pressing the appropriate key.
Key
S1
S2
S3
S4
N/A
Press to return to the AUTO MODE BACKUP ASSIGNMENT SUMMARY Screen.
Used to enter the prime channel number to switch to Backup Channel 2.
Press <CLR> or <NEXT> to abort programming (no switch parameters changed).
Press <ENT> to load the information on the screen into the switch parameter table.
Switching will occur immediately after pressing <ENT>.
CONTROL MODE CONFIGURATION
CONTROL MODE: FRONT PANEL
<FT PANEL> <TERM>
Label
FT PANEL Press to select Front Panel Control.
TERM Press to select Remote Terminal Control.
COMPUTER Press to select Command Interface Control.
NEXT Press to cycle to the next screen.
4–30
Function
<COMPUTER> NEXT
Function
Revision 15
MN-RCS20 and CD-RCS20