Comtech EF Data Radyne RCS20 Installation And Operation Manual page 63

RCS20 M:N Redundancy Switch
User Interfaces
Key
Numeric Keypad
4.3.2.2 TERMINAL PORT CONFIGURATION
This screen displays both the Terminal Baud Rate and the Terminal Emulation Type, and allows the user
to cycle to Subscreens to change the configurations. The baud rate may be any of the following:
19200
•
9600
•
2400
•
The emulation type may be any of the following:
ADDS VP
•
VT 100
•
WYSE 50
•
4.3.2.2.1 Programming steps:
1. Press <BAUD> to cycle to the TERMINAL PORT BAUD RATE Subscreen to change the
configuration. Press <EMUL> to cycle to the TERMINAL PORT EMULATION Subscreen to
change the configuration.
IMPORTANT
After changing the Terminal Port Baud Rate, power must be cycled before the baud
rate change takes effect.
Key
S1
S2
Label
Press <NEXT> to advance to next screen.
---
Press <CLR> to return to previous screen.
TERMINAL PORT CONFIGURATION
TERMINAL BAUD RATE : 19200
TERMINAL EMULATION : VT 100
BAUD EMUL
Label
BAUD Press to cycle to the TERMINAL PORT BAUD RATE Subscreen.
EMUL Press to cycle to the TERMINAL PORT EMULATION Subscreen.
4–31
Function
NEXT
Function
Revision 15
MN-RCS20 and CD-RCS20