Test Run; Check Whether Type Of Seating Is Set Correctly - AUMA SG 03.3 Operation Instructions Manual

Operation instructions

12. Test run

12.1 Check whether type of seating is set correctly (see page 55, subclause 16.9)
Figure G2
CLOSED (yellow) OPEN (green)
OFF
Switching off in the end positions must be by limit seating.
The type of seating can be set separately for direction CLOSE and
direction OPEN.
.
.
Set selector switch to position OFF (0), figure G1.
Select status indication
Press push button
Figure G1
Check if end positions of the limit switching are set correctly:
.
.
Engage manual operation as described under clause 6.2 on page 8.
Move actuator manually to the respective end position.
End position CLOSED reached: LED yellow: illuminated
End position OPEN reached:
The LED signals described here are standard settings. Deviating from this,
individual LED's can also signal another information (see page 18)
.
If the end positions are not set correctly, the limit switching must be set
anew, as described on page 13.
When end positions are set correctly, perform a test run in motor operation,
as described below.
.
Set selector switch (figure G3) to position LOCAL (I).
Figure G3
.
Operate actuator with push buttons
OPEN
.
Actuator runs in direction CLOSE: LED yellow: blinking
End position CLOSED reached:
Actuator runs in direction OPEN: LED green: blinking
End position OPEN reached:
:
S0
briefly, if necessary several times.
C
Push x times briefly
until
Indication in display:
LED green: illuminated
Indication in display:
- STOP - CLOSE
Indication in display:
LED yellow: illuminated
Indication in display:
Indication in display:
LED green: illuminated
Indication in display:
Part-turn actuators SG 03.3 – SG 04.3
with AUMATIC AC 01.1
appears
S0
CLOSED POSITION
OPEN POSITION
RUNNING CLOSE
CLOSED POSITION
RUNNING OPEN
OPEN POSITION
15