General Information About The Menu Design - AUMA SG 03.3 Operation Instructions Manual

Operation instructions
Lamp test
15.5 General information about
the menu design
15.5.1 LCD contrast setting
15.5.2 Navigation through the indications
Scrolling within a group:
Confirm selection:
Select group
S
Show settings:
Change settings:
Cancel process/back:
After the supply voltage is connected a function test of the LEDs is
automatically performed. All 5 LEDs must be illuminated for at least
3 seconds.
The indications on the display are divided into 3 main groups:
1) group
2) group
3) group
In the upper right corner of the display the group in which one is moving is
indicated. See example figure S1, page 20: Group
.
Either: Change setting via menu "
.
settings" below)
Or: Press button
(the above mentioned menus - groups
brightness of the LCD display continuously changes from bright to dark
and vice versa. When the button is released, the current brightness level
is saved under "
(Selector switch in position OFF or REMOTE)
.
To scroll within a group (see subclause 15.5):
Press push button "scroll"
the direction of the scrolling.
.
To reach a new menu or a subgroup:
Load the new selection with the push button "Confirm selection"
, or After the AUMATIC is switched on, the status indication S0 is shown on the
M D:
display.
.
Change from the group
group
.
Press
Change from the group
group
Press
.
skipped).
Change from any group
Press push button
.
To cancel a process or to go back to the previous indication:
Press push button
= Status indications, 15.5.3
S
= Menu indications, see 15.5.4
M
= Diagnosis indications, see 15.5.5
D
in the status page
C
".
CONTRAST
,
(Status indications
S
(Menu indications):
M
and hold it for approx. 2 seconds until the group
C
(Status indications
S
(Diagnosis indications):
D
and hold it until the group
C
or
M D
briefly.
C
.
.
Set selector switch to position OFF or REMOTE.
.
Select group .
M0
Make selection: e.g.
.
confirm selection with
"Select " " and confirm with
VIEW
.
.
Set selector switch to position OFF.
.
Select group .
M0
Make selection: e.g.
.
confirm selection with
.
"Select " " and confirm with
EDIT
.
Enter password (see page 22 ).
Change value.
.
C
Part-turn actuators SG 03.3 – SG 04.3
with AUMATIC AC 01.1
= Status indications
S
LANGUAGE/CONTRAST
and hold it. After approx. 10 s
S0
, , - are hereby skipped) the
S M D
. The triangles in the display show
S0,S1,S2,S3
S0,S1,S2,S3
appears (menu indications M are
D0
back to the group :
S0
"
M0 LANGUAGE/CONTRAST"
.
.
"
M0 LANGUAGE/CONTRAST
.
.
" (see "Change
.
) to the
appears.
M0
) to the
and
" and
19