Figure 9-13: 160 Option Test Selection Screen - Ametek i Series User Manual

User Manual
9.1.2.6 CIGui32 -160 Control Window
To access the –160 option, select the RTCA/DO-160 Revision E from the Applications menu of
the CIGui32 main screen or click on the 160 button in the toolbar. The 160 Tables control window
will open selecting the last power group that was selected in a previous instance. It may still be
necessary to select the desired power group first however. Also verify that the selected power
group in the 160 screen is the correct one for the EUT being tested.
The 160 tests can be operated from the 160 test screen. This screen contains three main tabs
located along the top edge of the window. The following tabs are available. Click on the tab name
for additional help on how to use each tab.
Tab
Test Selection
Test Control
EUT Performance
Measurements
156

Figure 9-13: 160 Option Test Selection Screen.

Description
This tab allows the operator to select the library of test files to use (Select
Airframe) and the relevant Power group. It also displays the AC power source
settings that are in effect on the right hand side. Available power group
selections are shown below the airframe selection field. The table shown at
the bottom of this tab shows the available test sections that can be selected.
This table matches the test outline of the RTCA/DO-160 test standard.
This tab provides information on the test sequence that is presently selected
and also contains the execution controls. It shows the progress of any test that
is executing.
This tab may be used to display EUT performance data as measured by the
power source‟s advanced data acquisition system. If the source used does not
support advanced measurement function such as waveform capture and FFT,
some of the information in this tab may not be displayed.
i Series / iX Series