Figure 4-26: Measurement Cal Factors Menu - Ametek i Series User Manual

User Manual
4.2.13 MEASUREMENT CAL FACTORS Menu
The MEASUREMENT CAL FACTORS menu provides access to the measurement calibration
parameters. For three phase configurations, the PHASE keys toggle between the three
calibration screens for each phase. These parameters are password protected and can only be
changed after the calibration password has been entered. Refer to the calibration section in this
manual for details on performing a calibration.
The following calibration factors are available from this menu:
Entry
VOLT FS
VOLT 0
VOLT FS HT
VOLT 0 HT
CURR FS
CURR 0
CURR FS HT
CURR 0 HT
i Series / iX Series

Figure 4-26: MEASUREMENT CAL FACTORS menu

Description
Full scale voltage measurement calibration factor.
Zero offset voltage measurement calibration factor.
Temperature compensated full scale voltage measurement
calibration factor.
Temperature compensated zero offset voltage measurement
calibration factor.
Full scale current measurement calibration factor.
Zero offset current measurement calibration factor.
Temperature compensated full scale current measurement
calibration factor.
Temperature compensated zero offset current measurement
calibration factor.
75