Connecting Cpv-Sc Valve Terminal; Pilot Control (Pilot Air) - Festo CPV-SC Series Manual

Valve terminal

Hide thumbs Also See for CPV-SC Series:

Table of Contents

3. Installation

3.3

Connecting CPV-SC valve terminal

3-8

1. If necessary, loosen the locking screw (e.g. with the

loosening tool QSO from Festo) or press the locking ring

of the screw connector.

2. Pull out the tubing.

3. If necessary, replace the screw connector with a blanking

plug 3.

Fig. 3/2: Disconnecting the tubing

Note

– Operate the CPV-SC valve terminal whenever possible

with unlubricated pilot air supply (port 12/14). Other-

wise observe the instructions in the section "Com-

pressed air preparation".

– In the case of CPV-SC valve terminals with internally

branched pilot air supply, the above-mentioned note

also applies to the supply air (connection 1).

Pilot control can be undertaken with internal or external aux-

iliary pilot air, depending on the left-hand end plate. The fol-

lowing end plate pairs are offered for the CPV-SC valve ter-

minal:

Festo P.BE-CPVSC-EN en 1206f

Table of Contents

Table of Contents