Fitting The Identification Plate (Optional) - Festo CPV-SC Series Manual

2. Fitting
2.4

Fitting the identification plate (optional)

Fitting
1
4 recesses in the
valve terminal
2
4 snap hooks
3
Identification
plate
Fig. 2/8: Fitting the identification plate
Festo P.BE-CPVSC-EN en 1206f
If desired, you can fit an identification plate to the CPV-SC
valve terminal. You can insert a label into this plate for ident-
ifying the valve plates.
The identification plate can be fitted in one of two ways:
– swivelling upwards. In this case the manual overrides are
freely accessible (
– swivelling downwards. In this case, the manual overrides
are covered
Proceed as follows:
1. Clip the identification plate into the recess provided for
this purpose in the CPV-SC valve terminal, as shown in the
diagram).
1
1
Fig. 2/8 and Fig. 2/9)
2
1
3
2-15