Ftp Account Name; Ftp Passive Mode; Ftp Password - Siemens HIPATH 8000 HIPATH 8000 Administrator's Manual

FTP account name

• Refer to the documentation of your FTP server for information about
the FTP account.
• Value range table:
Permitted values
Length max.
• Editing by phone: Text Editor
page 75

FTP passive mode

If the passive FTP (also "passive mode") is activated, the telephone trans-
mits a PASV command, the server opens a port and transmits this together
with the IP address to the telephone. Usually both sides use a port higher
than 1023.
This method is used if the server cannot reach the telephone. This is for
example the case if the telephone is switched by a router which translates
the telephone address using NAT, or if a firewall shields the network of the
telephone from external attacks.
page 75

FTP password

• Enter the password defined in the
cessing this server.
• The password must correspond to the
password on the server.
• Value range table:
Permitted values
Length max.
Default value
• Editing by phone: Password Editor
• After factory reset the FTP password is replaced with the string
"123abc".
page 75
alphanumeric
92 digits
page 155.
page 118
page 118
alphanumeric
24 digits
123abc
page 118
Alphabetical Reference
FTP server as password for ac-
FTP username and match the
page 158.
187