Installation; Prerequisites; Connecting To The Network - Siemens HIPATH 8000 HIPATH 8000 Administrator's Manual
Siemens ip phone - ip telephone user manual
Hide thumbs
Also See for HIPATH 8000 HIPATH 8000:
- Administration manual (260 pages) ,
- User manual (217 pages) ,
- Operating manual (193 pages)
Table of Contents
Advertisement
Installation
Prerequisites
The advance acts as an endpoint client on an IP telephony network, and
has the following network requirements:
•
An Ethernet connection to a network with SIP clients and servers (re-
quired).
•
A Dynamic Host Configuration Protocol (DHCP) server (optional).
•
Either a Call Control System
– Proxy server — There must be a device running RFC 3261 SIP-com-
pliant software.
– Voice packet gateway (optional) — Required if your VOIP Network is
connected to the Public Switched Telephone Network (PSTN).
•
or a voice packet gateway if the phone is used in gateway routing mode
page 216.
Connecting to the Network
You have to connect the advance first to the LAN and then to the
power supply.
The advance has two RJ-45 ports labelled "10/100 LAN" and "10/100 PC. "
Each port supports 10/100 Mbps half- or full-duplex connections.
We recommend that you use the port setting "Auto"
ports for auto detection of transferring speed and type of connected cable
(either straight-through or crossed).
Installation
page 194 on all
19
Advertisement
Table of Contents
