Layer 2 Voice; Lan Port Settings; Last Restart; Ldap Server Ip Address - Siemens HIPATH 8000 HIPATH 8000 Administrator's Manual

Alphabetical Reference

Layer 2 voice

Can be defined only if the
vice (QoS)).

LAN port settings

•
•
•

Last Restart

•

LDAP Server IP Address

•
•

LDAP server Port

•
•
•
•
194
page 58 page 117
Use this function to define the bandwidth at which the optiPoint 410/
420 family S V7 .0 should be run. The required value depends on the
bandwidth that the switch or router supports in the network.
Bandwith
Automatic
10 Mbit/s full
10 Mbit/s half
100 Mbit/s full
100 Mbit/s half
* The data can be transmitted and received simultaneously.
** The data can only be transmitted or received.
The PC port can setup in the same way as the LAN port.
The change will only have effect if you restart the phone.
page 60 page 123
Use this function to view the date and time of the last restart
page 97 of the optiPoint 410/420 family S V7 .0.
page 97
If an LDAP server is being used, enter the
er here.
IP editor in optiPoint 410/420 family S V7 .0
page 79 page 136
If an LDAP server is being used, enter the
communication with this server.
Valid values: 1 ... 65535.
Default port is 389
Number editor in optiPoint 410/420 family S V7 .0
page 79 page 136
Layer 2 support is activated (
Use
in standard case (automatic detection)
in 10 Mbit networks in full duplex
in 10 Mbit networks with half duplex
in 100 Mbit networks in full duplex
in 100 Mbit networks with half duplex
Quality of Ser-
*
process
**
process
1
process
2
process
IP address of this serv-
page 159.
Port number here for
page 157.