Basic Administration; Access To The Phone Administrator And Diagnostics Menu; Administrator Menu - Siemens HIPATH 8000 HIPATH 8000 Administrator's Manual

Basic Administration

Basic Administration
The phone is factory preconfigured to allow for a minimum of configuration
activites required on the unit itself. A number of parameters can be config-
ured centrally by using a DHCP server. When the phone is connected to
the network it will react as follows:
•
•
Access to the Phone Administrator and Diagnostics
Menu

Administrator menu

The following steps describe the access to the optiPoint 410/
420 economy/economy plus/standard/advance administration menu,
starting from idle state.
1. Select the menu „05=Setup" by pressing the key
2. Select the administrator menu by pressing the key
3. Enter the administrator password (default: „123456").
4. Now the first menu item in the administrator menu is shown:
You can change the sub-menu by pressing the keys
open the menu „01=Network" by pressing the key
48
If your network use a DHCP server, the telephone will try to get its IP
Address, IP Address Mask, SIP Addresses (server, gateway, registrar),
SNTP Server Address Configuration Download Server Address and
Time Offset from the DHCP server (completely list see
In this case the telephone will boot with the IP address and will get the
exact time from the configured SNTP server.
You only have to configure the Terminal number, SIP user ID and pass-
word and the language
If the DHCP server is not available or configured to provide these pa-
rameters, the telephone will become idle and has to be manually con-
figured page 51.
Menu:
05=Setup?
Confirm with the key
Enter admin password
The entry is masked by asterisks „*" .
Enter admin password
******
Confirm with the key
Administration
01=Network>
page 50.
>
:
.
:
.
page 38).
>
several times.
j
.
< >
or you can
:
.