Radio; Push Button Adjustment; Antenna Installation - Lincoln Continental 1964 Shop Manual

(315)
PART
16-4
RADIO
16-21
Section Page
1 Description and Operation ................ 16-21
2 In-Car Adjustments and Repairs ............ 16-21
3 Removal and Installation ................. 16-21
II
DESCRIPTION AND OPERATION
An AM and an AM/FM radio are
available for 1964. Both radios have
push button tuning as well as man-
ual tuning. An electrically operated
antenna is mounted on the right
fender. The antenna switch is located
under the rear edge center of the
crash pad. A rear seat speaker and a
EJ
IN-CAR ADJUSTMENTS AND REPAIRS
PUSH BUTTON
ADJUSTMENT
Turn the radio on. Pull out the
desired push button and reduce the
volume to a low value. Tune in the
desired station with the manual tun-
ing knob. The station is correctly
tuned in when the clearest tone is
heard. Carefully push the button in
all the way, then release it.
Adjust the remaining buttons and
check all the positions for repeat ac-
curacy. Repeat the procedure for any
EIREMOVAL AND INSTALLATION
RADIO
REMOVAL
1. Disconnect the battery ground
cable.
2. Remove the radio control
knobs, and the heater control knobs.
3. Remove the 7 upper screws from
the instrument panel reinforcement
bracket. Remove the 5 upper instru-
ment panel bezel mounting screws
and remove the reinforcement brack-
tft. Remove the
5
lower instrument
panel bezel mounting screws, and
remove the bezel.
4. Remove the right and left sun
visors, and the right and left wind-
shield pillar garnish mouldings.
5. Remove the retaining screws
from the upper front instrument
panel. Lift the panel and disconnect
the photo tube lead at the quick dis-
connect and remove the upper panel.
6. Remove the radio support
mounting bolt from the upper panel
area. Remove the radio mounting
plate at the face of the radio.
7. Pull the radio out of the in-
strument panel and disconnect the
antenna lead, speaker lead and
power lead and remove the radio
(Fig. 4).
INSTALLATION
1. Connect the speaker lead,
power lead and antenna lead to the
radio and insert the radio into the
instrument panel.
2. Install the upper mounting bolt
to the radio through the upper in-
strument panel.
3. Install the mounting plate on
the face of the radio and the in-
strument panel.
4. Connect the battery and check
the operation of the radio.
GREEN
(DOWN
I
:
i
I
\
~ ~
J
I
\.\:-~
',"\
',
\
',·<._:j:-.:~~---
~ --...... -r
RED
FIG.
1-Antenna Installation
front speaker are used. Figs. 1 and
3 show the radio schematic diagrams.
buttons that shift from the correct
tuning point.
On the AM/FM radio push one
AM button all the way in before ad-
justing the AM buttons. Push one
FM button all the way in before
adjusting the FM buttons.
5. Place the upper front instru-
ment panel in position, connect the
photo tube lead and insta11 the panel
mounting screws.
6. Install the center instrument
panel bezel.
7. Install the heater and radio con-
trol knobs.
8. Install the right and left wind-
shield pillar garnish mouldings, and
the right and left sun visors.
K1387-B