Lincoln Continental 1964 Shop Manual page 181

9-4
FIG.
&-Ignition Switch
Test-Rotunda Tester
82002-A
3. Turn all of the accessories and
lights off. '
4. Turn the ignition switch on.
RESULTS. If the voltmeter read-
ing is 6.6 volts or less, the resistance
wire is satisfactory.
If the voltmeter reading is greater
than 6.6 volts, replace the resistance
wire.
~ ~
--
1-
--
- _.,..
'
.
-
~ :~·
~""
,.
~·" ~
,f
·fIG. 7
-Ignition Switch
Test- Svn Tester
82003-A
GROUP 9-IGNITION SYSTEM
FIG.
8-Resistance Wire
Test-Rotunda Tester
82004-A
Starting Ignition Circuit Test
PROCEDURE
1. Connect the voltmeter leads as
shown in Figs. 10 and 11.
2. Disconnect and ground the coil
to distributor high tension lead at the
distributor.
3. With the ignition switch off,
crank the engine by jumping the
FIG.
9-Resisfance Wire
Test-Sun Tester
82005-A
{180}
82006-A
FIG.
10-Starting Ignition
Circuit Test-Rotunda Tester
ignition switch at the solenoid while
observing the voltage drop.
RESULTS. If the voltage drop
is 0.1 volt or less, the starting igni-
tion circuit is satisfactory.
If the voltage drop is greater than
0.1 volt, clean and tighten the termi-
nals in the circuit or replace the
wiring as necessary.
FIG.
11-Starting Ignition
(if(uit Test-Sun Tester
82007-A