(287)
PART 15-3-SWITCHES, CIRCUIT BREAKERS AND FUSES
15-11
8. If a new lock cylinder is to he
installed, insert the key in the cyl-
inder and turn the key to the ac-
cessory position. Place the lock and
key in the ignition switch,
depres~
the pin slightly (Fig. 5). and turn
the key counterclockwise. Push the
lock cylinder into the switch. Turn
the key to check the lock cylinder
operation.
FIG.
3-Headlight Beam
Selector Switch
9. Connect the battery cable and
check the ignition switch operation.
MAP LIGHT SWITCH OR
ANTENNA SWITCH
1. Remove two retaining screws
from the trim plate and remove tlhe
plate.
~~
FIG.
4-stop Light
Switch
2. Disconnect the wires from the
switch and remove the switch from
the retaining clip.
GLOVE COMPARTMENT
LIGHT SWITCH
Pull the switch from the retain-
ing flange in the glove compartment
and disconnect the wires.
FIG.
5-lgnition
Switch and Lock