Transmission; Seat Installation; Front Seat Back; Front Seat Cushion - Lincoln Continental 1964 Shop Manual

{369)
P D ASSEMBLY
VIEW BB
ASSEMBLED (
}
/
/
or:===
---~
FIG.
5-Rear Seat Back Assembly
screws that secure both relays to the
mounting bracket and remove the
relays.
3. Secure both relays to the mount-
ing bracket with two sheet metal
screws. Make sure that the motor
control relay (four-prong connector)
is toward the driver's side of the seat.
4. Connect each connector to its
respective relay.
TRANSMISSION
1. Disconnect the three leads from
the three solenoids on the transmis-
sion (Fig. 1) .
2. Remove the cable housing re-
tainer from each end of the transmis-
PART 18-2-SEATS
VIEW AA
R1255-A
'>fOn.
Separate the six cables and
housings from the transmission.
3. Remove the two cap screws and
lock washers that secure the trans-
mission to the mounting bracket.
Separate the transmission from the
mounting bracket.
4. Secure the transmission to the
mounting bracket with two lock
washers and cap screws.
5. Slip the six cables and hous-
mgs into their respective ports. Install
the two cable housing retainers.
6. Connect the first lead to the
front solenoid, the second lead to the
center solenoid and the third lead to
the rear solenoid.
18-9
SEAT INSTALLATION
1. Secure the seat to the regulator
with four attaching screws.
2. With a helper, carefully posi-
tion the seat and regulator in the car.
3. Secure the motor mounting
bracket to the floor pan with a nut
and washer.
4. Secure each seat actuator ( regu-
lator) to the floor pan with a cap
screw, two washers and a nut.
5. Connect the main harness to the
harness leading to the 20-ampere cir-
cuit breaker (Fig. 1).
6. Connect the ground lead to the
battery.
7. Check the operation of the seat
to make certain that it moves in all
directions.
FRONT SEAT BACK
1. Open the door and install a
cover.
2. Position the front seat to the
top rear of its travel, and remove the
seat track to seat cushion retaining
screws.
3. Disconnect the seat wiring re-
taining clips and the wiring.
4. Remove the front seat assembly
and place on a clean bench or work-
ing surface.
5. Remove the front seat back
cover panel and retaining clips.
6. Remove the front seat cushion
side shield assembly and the shield
support bracket.
7. Remove the seat back to center
arm rest frame retaining screws (Fig.
3).
8. Remove six hog rings retaining
the seat cushion cover to the seat
cushion frame.
9. Remove the seat back to seat
cushion outer retaining screw and
remove the seat back assembly.
10. Remove the seat back cover or
pad and transfer the listing wires to
the new cover.
11. To install the cover or pad
reverse the removal procedure.
FRONT SEAT CUSHION
1. Open the door and install a
cover.
2. Position the front seat to the
top rear of its travel, and remove the
seat track to seat cushion retaining
screws.
3. Disconnect the seat wiring re-
taining clips and the wiring.
4. Remove the front seat assembly
and place on a clean bench or work-
ing surface.