Table of Contents
Advertisement
17-16
GROUP 17-BODY, DOORS AND WINDOWS
(340)
assembly to gain access to the license
lamp wire. Disconnect the wire.
5. The individual parts of the
bumper assembly are bolted together
and can be replaced as necessary
(Fig. 5).
6. To install the bumper assembly,
reverse the removal procedure. Ad-
just the position of the bumper be-
fore tightening the bolts.
EXTERIOR MOULDINGS
Figure 6 shows the various methods
of retaining the body outside mould-
ings. Before removing any outside
moulding, it should be determined
by the type of moulding retainer
used whether the respective door
trim, quarter trim, or luggage com-
partment trim should be removed.
Bolt-on
moulding
retainers
may
require removal of the trim panel
before removing the moulding.
Advertisement
Table of Contents
Troubleshooting
