Commissioning; Commissioning The Drive - Siemens SINAMICS S120 Operating Instructions Manual

Commissioning

For your personal safety and to prevent material damage when working on the converter,
always carefully observe the safety instructions and the following five safety rules, according
to EN 50110‑1 "Working in a voltage-free state". Apply the five safety rules in the sequence
stated before starting work on the converter.
Five safety rules
1. Disconnect the system.
Disconnect the auxiliary circuits, for example anti-condensation heating
2. Prevent reconnection.
3. Make sure that the equipment is at zero voltage
4. Ground and short-circuit
5. Cover or isolate nearby components that are still live.
To energize the system, apply the measures in reverse order.
6.1

Commissioning the drive

Detailed information on commissioning and operating the converter is provided in the
Commissioning Manual designated for the commissioning engineer.
You can find the commissioning instructions on the customer DVD.
Incorrect commissioning
Malfunctions can occur as a result of incorrect commissioning and parameterization. This can
result in premature failures and subsequent damage to the drive and the drive system
components. This can result in death, serious injury or material damage. Incorrectly
performed commissioning can result in the warranty becoming null and void.
This drive may only be commissioned by electrical technicians that have been adequately
trained on this product, and have experience with commissioning this product and the
associated plant and system components. The electrical technician commissioning the
equipment must be trained on the specific product as a result of the differences between the
individual products, e.g. regarding topology and closed-loop control.
Obtain information about the range of SITRAIN training courses available through your local
contact person. Make use of the support and services offered by the responsible Siemens
Service Center when commissioning this equipment. You can find the relevant contact person
under "Service & Support".
Siemens Drives & PLCs
Applications for Cabinet Modules, liquid cooled
Operating Instructions, 04/2015, A5E35974555A
WARNING
6
93