Siemens SINAMICS S120 Operating Instructions Manual page 19

Non-observance of proper usage
Improper use of the devices described can result in death, severe injury or material damage.
Therefore, please adhere to all instructions for proper usage.
The nominated person in control of an electrical installation must ensure that the following
points are observed:
● Follow the local and industry-specific safety and setup regulations. Observe the
requirements listed in the directives, specified in the "Technical specifications" in Section
"Standards and regulations". Ensure that the specific safety and construction regulations
and regulations for using personal protective equipment are adhered to during all work.
● The operating instructions and the complete product documentation are always available
when carrying out any work.
● The technical specifications as well as the specifications relating to the permissible
installation, connection, ambient and operating conditions are taken into account at all times.
● Only qualified personnel or personnel supervised by responsible, skilled specialists are
allowed to carry out basic planning and all work on the drive.
● During shipping, specific transport conditions are adhered to.
● Assembly is performed according to assembly instructions. Separate cabinet units are
connected properly (cables and busbars).
● All instructions for EMC-compatible installation, cabling, shielding, grounding, and for
adequate auxiliary power supply are to be observed.
● Commissioning is only to be performed by qualified personnel trained for that purpose in
accordance with the commissioning instructions.
● System configuration is carried out by an experienced system integrator. Further system
components such as the circuit-breaker, transformer, cables, and motor are adjusted for
drive operation.
● The drive is only operated in conjunction with the engineered components.
● Different operating modes, overloads, load cycles, and differing environmental conditions
are permitted only after special arrangement with the manufacturer.
Note
Make use of the support and services offered by the relevant service center for planning,
installation, commissioning, and servicing work. You can find the relevant contact person under
"Service & Support (Page 139)".
Siemens Drives & PLCs
Applications for Cabinet Modules, liquid cooled
Operating Instructions, 04/2015, A5E35974555A
WARNING
1.6 Information for persons responsible for plants and systems
Safety notes
19