Siemens SINAMICS S120 Operating Instructions Manual page 149

Activity
SMC30
Sensor Module
VSM10 Voltage Sensing Module
Cabinet-Mounted
Fan power supply
Auxiliary power generation in the
Line Connection Module
Terminal Module TM54F
Safe Brake Adapter SBA 230 V AC To control the brake, a connection is established
Operation in an IT supply system
Circuit breaker in withdrawable unit
design
Output-side circuit breaker
Current transformer upstream of
the main switch
Siemens Drives & PLCs
Applications for Cabinet Modules, liquid cooled
Operating Instructions, 04/2015, A5E35974555A
The correct encoders are connected to the SMC10
Sensor Module.
("SINAMICS S120 Cabinet Modules / Options / K
50, Sensor Module Cabinet-Mounted SMC30" Man‐
ual).
To commission the function, the permanent-mag‐
net synchronous machine without encoder must be
input and "Flying restart" activated with p1200.
("SINAMICS S120 Cabinet Modules / Options / K
51, Voltage Sensing Module Cabinet-Mounted
VSM10" Manual).
Voltages 1 AC 230 V and 24 V DC are fed in exter‐
nally.
("SINAMICS S120 Cabinet Modules / Options / K
70, Fan Power Supply" manual).
The phase is connected to the correct transformer
tap.
The correct voltage assignment is complied with.
("SINAMICS S120 Cabinet Modules / Options /
K76, Auxiliary Power Generation in the Line Con‐
nection Module" Manual).
The connection has been correctly established.
("SINAMICS S120 Cabinet Modules / Options /
K87, Terminal Module TM54F" manual).
between -X14 on the Safe Brake Adapter and the
holding brake.
("SINAMICS S120 Cabinet Modules / Options /
K88, Safe Brake Adapter SBA AC 230 V" Manual)
The monitoring of the surge arresters and the up‐
stream fuses is connected to terminal ‑X700.
("SINAMICS S120 Cabinet Modules / Options /
L21, Operation on an IT Supply System" Manual).
The feedback signal contact is wired.
("SINAMICS S120 Cabinet Modules / Options /
L25, Circuit Breaker in a Withdrawable Unit Design"
Manual).
The control is parameterized.
("SINAMICS S120 Cabinet Modules / Options /
L34, Output-Side Circuit Breaker" Manual).
The measuring connections of the current trans‐
formers are wired.
("SINAMICS S120 Cabinet Modules / Options /
L41, Current Transformer Before the Main Switch"
Manual).
Checklists and forms
C.2 Electrical installation: Checklist
Available/performed?
149