Rtd.lo - Calibrating Minimum Resistance Value; Rtd.hi - Calibrating Maximum Resistance Value; Hour - Setting Hours; Min - Setting Minutes - gefran 650 Abbreviated Manual

Acronym
C.HIGH
The parameter appears if you are calibrating a custom I.MAIN or I.SPR input in current or voltage.
To calibrate:
• apply the current or voltage value corresponding to maximum scale value to the selected input;
• press the
Unit of measurement:
Options:

4.25.5. RTD.LO - Calibrating minimum resistance value

Acronym
RTD.LO
The parameter appears if you are calibrating a custom I.MAIN RTD input.
To calibrate:
• apply a resistance corresponding to minimum scale value to the main input (for example, 18.52 Ω for Pt100 ;
• press the
Unit of measurement:
Options:

4.25.6. RTD.HI - Calibrating maximum resistance value

Acronym
RTD.HI
The parameter appears if you are calibrating a custom I.MAIN RTD input.
To calibrate:
• apply a resistance corresponding to maximum scale value to the main input (for example, 390.48 Ω for Pt100);
• press the
Unit of measurement:
Options:

4.25.7. HOUR - Setting hours

Acronym
HOUR
The parameter shows and sets the hours on the Real Time Clock, if U.CAL = RTC.
Unit of measurement:
Options:

4.25.8. MIN - Setting minutes

Acronym
MIN
The parameter shows and sets the minutes on the Real Time Clock, if U.CAL = RTC.
Unit of measurement:
Options:

4.25.9. SEC - Setting seconds

40524-04 Rev0
Gefran 650/1250/1350 Temperature Controller – Abbreviated Manual
Scrolling message
key to acquire the calibration value.
-
-
Scrolling message
key to acquire the calibration value.
-
-
Scrolling message
key to acquire the calibration value.
-
-
Scrolling message
Hours
0...23
Scrolling message
Minutes
0...59
4. CONFIGURATION
Submenu Attributes
US.CAL R W
Submenu Attributes
US.CAL R W
Submenu Attributes
US.CAL R W
Submenu Attributes
US.CAL R W
Submenu Attributes
US.CAL R W
133