But.1 - Selecting Function Key 1; But.2 - Selecting Function Key 2 - gefran 650 Abbreviated Manual

4. CONFIGURATION

4.23.1. but.1 - Selecting function key 1

Acronym
but.1 KEY FUNCTION
The parameter shows and sets the function assigned to key 1 (
Unit of measurement:
Options:

4.23.2. but.2 - Selecting function key 2

Acronym
but.2 KEY FUNCTION
The parameter shows and sets the function assigned to key 2 (
Unit of measurement:
Options:
4.23.3. but.3 - Selecting function key 3
Acronym
but.3 KEY FUNCTION
The parameter shows and sets the function assigned to key 3 (
Unit of measurement:
Options:
124
40524-04 Rev0
Gefran 650/1250/1350 Temperature Controller – Abbreviated Manual
Scrolling message
-
NONE
= No function assigned
AU-MA = Automatic-Manual control
LO-RE = Local-remote setpoint mode
HOLD = Hold main input value
AL.ACK = Reset alarm latches
S.TUNE = Activate Self-Tuning
A.TUNE = Activate Auto-Tuning
OUT.S.R = Set/reset outputs set with BUT.SR function
INT.RS = General reset
CAL.HB = Calibrate HB alarm
if the Multiset function is enabled:
SP.SEL = Select setpoint SETP1...SETP2
if enabled Options Logics
FB.IN = Input Function Blocks
Scrolling message
-
As per but.1
Scrolling message
-
As per but.1
) of the controller.
) of the 1350 controller.
) of the 1350 controller.
Submenu Attributes
HMI R W
Submenu Attributes
HMI R W
Submenu Attributes
HMI R W