Res.t - Defining The Timer Reset Command Logic; Band - Band For Timer Count; End - Selecting The Function Activated At End Of Count; Timer - Timer Value - gefran 650 Abbreviated Manual

4.20.5. rES.t - Defining the timer reset command logic

Acronym
rES.t LOGIC TYPE OF TIMER RESET
The parameter shows and sets the type of logic used to command the timer reset.
With positive logic, the timer is reset with "object" active.
With negative logic, the timer is reset with "object" inactive.
Unit of measurement:
Options:

4.20.6. BAND - Band for timer count

Acronym
BAND SYMM SP BAND WHERE TIMER IS ACTIVE
The parameter shows and sets the symmetrical band around the setpoint within which the timer count is on.
The parameter appears if the parameter F.tiM = STABL
If the parameter equals "0.0" the count is immediate as soon as the setpoint is reached for the first time.
Unit of measurement:
Options:

4.20.7. End - Selecting the function activated at end of count

Acronym
End FUNCTION WHERE TIMER IS OVER
The parameter shows and sets the function that is activated when the timer ends the count.
The parameter appears if the parameter F.tiM = ST.STP or STABL.
Unit of measurement:
Options:

4.20.8. TIMER - Timer value

Acronym
TIMER ACTUAL TIME
The parameter shows and sets the timer value.
Unit of measurement:
Options:
40524-04 Rev0
Gefran 650/1250/1350 Temperature Controller – Abbreviated Manual
Scrolling message
-
POSIT = Positive logic
NEGAT = Negative logic
Scrolling message
% of full scale of main input
0.0...25.0
Scrolling message
-
NONE = None: control continues with actual setpoint
OFF = Software off
if the Multiset function is enabled:
SP1-2 = Change setpoint SP1/SP2
Scrolling message
Minutes or Seconds according to the selection set in the MODE submenu, parameter tMEr
0...9999
4. CONFIGURATION
Submenu Attributes
TIMER R W
Submenu Attributes
TIMER R W
Submenu Attributes
TIMER R W
Submenu Attributes
TIMER R W
117