Msg.sb - Selecting The Message Assigned To Sbr; Lang - Selecting Language For Messages; Speed - Message Scrolling Speed; Backl - Backlighting Level - gefran 650 Abbreviated Manual

4.23.10. MSG.SB - Selecting the message assigned to Sbr

Acronym
MSG.SB NUM SCROLLING MSG WHEN MAIN IN IS SB ERR
The parameter shows and sets the number of the message assigned to Err (sensor break in short circuit or input values
above maximum limit), i.e., the scrolling message shown on the display.
For more information on scrolling messages, see paragraph "3.1.2.2. Scrolling messages" on page 34.
If the parameter is set to "0" no message will be displayed for Sbr.
As default, MSG.SB is assigned the message "4" (for LANG1 corresponds to ""SENSOR BROKEN", for LANG2 corre-
sponds to "SONDA APERTA").
Unit of measurement:
Options:

4.23.11. LAnG - Selecting language for messages

Acronym
LAnG MESSAGE LANGUAGE
The parameter shows and sets the language for the scrolling messages.
Unit of measurement:
Options:

4.23.12. SPEED - Message scrolling speed

Acronym
SPEED SCROLLING MESSAGE SPEED
The parameter shows and sets the message scrolling speed.
"1" corresponds to maximum scrolling speed, "10" to minimum speed.
With "0" the message does not scroll and the display shows first 5 characters (on models 650 and 1250) or the first 7
characters (on model 1350).
Unit of measurement:
Options:
Note:

4.23.13. BACKL - Backlighting level

Acronym
BACKL BACKLIGHT LEVEL
The parameter shows and sets the backlight level on the display (when the controller is on) 10 seconds after the last key
has been pressed.
With "0," the backlight does not switch off, but goes to the minimum useful level for reading the display.
The backlight goes to maximum level when any key is pressed.
Unit of measurement:
Options:
40524-04 Rev0
Gefran 650/1250/1350 Temperature Controller – Abbreviated Manual
Scrolling message
Message number
0...25
Scrolling message
-
LANG1 = Language 1 (English)
LANG2 = Language 2 (Italian)
LANG3 = Language 3
Scrolling message
-
0...10 (default = 3)
Messages with the description of the parameters always flow at a constant speed.
NOT are subjected parameter setting SPEED
Scrolling message
-
0...10 (default = 8)
4. CONFIGURATION
Submenu Attributes
HMI R W
Submenu Attributes
HMI R W
Submenu Attributes
HMI R W
Submenu Attributes
HMI R W
127