To Connect Using Usb - Xerox B1022 User Manual

Getting Started
C C o o n n n n e e c c t t i i n n g g t t h h e e P P r r i i n n t t e e r r t t o o a a W W i i r r e e l l e e s s s s N N e e t t w w o o r r k k
If you purchased a Wireless Network Adapter, you can connect the device to a wireless network. If
the device is connected to a wired network, you can configure wireless settings using Xerox
CentreWare Internet Services. For details on configuring wireless network settings, refer to the
®
System Administrator Guide at www.xerox.com/office/B1022_B1025docs.
Note: Before configuring wireless network settings, install the Xerox Wireless Network Adapter
Kit. For information, refer to the Hardware Install and Setup instructions that are included with
the kit.
C C o o n n n n e e c c t t i i n n g g t t o o a a C C o o m m p p u u t t e e r r U U s s i i n n g g U U S S B B
To connect using USB, one of these operating systems is required:
• Windows 7 or later
• Windows Server 2008 or later
• Macintosh OS X version 10.9 or later
To connect the printer to the computer using a USB cable:
1. Connect the B end of a standard A/B USB 2.0 cable to the USB Port on the rear left side of the
printer.
2. Connect the A end of the USB cable to the USB port on the computer.
3. If the Windows Found New Hardware Wizard appears, select Cancel.
4. Install the print drivers. For details, refer to
36 Xerox ® B1022 Multifunction Printer
User Guide
Installing the Driver Software.
®