INVT Goodrive 200A Operation Manual page 42

inverters
Goodrive200A
Function
Name
code
ACC time of
the starting
P01.06
step of S
curve
DEC time of
the ending
P01.07
step of S
curve
P01.08 Stop mode
Starting
P01.09 frequency of
DC braking
Waiting time
P01.10 before DC
braking
DC braking
P01.11
current
DC braking
P01.12
time
Detailed instruction of parameters
1: S curve
0.0~50.0s
0: Decelerate to stop: after the stop command
becomes valid, the inverter decelerates to reduce
the output frequency during the set time. When
the frequency decreases to 0Hz, the inverter
stops.
1: Coast to stop: after the stop command
becomes valid, the inverter ceases the output
immediately. And the load coasts to stop at the
mechanical inertia.
Starting frequency of DC braking: start the DC
braking when running frequency reaches starting
frequency determined by P1.09.
Waiting time before DC braking: Inverters block
the output before starting the DC braking. After
this waiting time, the DC braking will be started
so as to prevent over-current fault caused by DC
braking at high speed.
DC braking current：The value of P01.11 is the
percentage of rated current of inverter. The
bigger the DC braking current is, the greater the
braking torque is.
DC braking time: The retention time of DC brake.
If the time is 0, the DC brake is invalid. The
inverter will stop at the set deceleration time.
Setting range of P01.09: 0.00Hz~P00.03
(the Max. frequency)
37
Function parameters
Default
Modify
value
○
0.1s
○
0.1s
○
0
○
0.00Hz
○
0.00s
○
0.0%
○
0.00s