Table of Contents
Advertisement
®
IntesisBox
BACnet/IP Server - KNX
3. Quick Setup
1. Install LinkBoxBacnet. Details in section 5
2. Install IntesisBox in the desired installation site (DIN rail mounting inside a metallic
industrial cabinet connected to ground is recommended).
3. Power up and connect the communication cables. Details in section 3.
4. Open LinkBoxBacnet, open a project or create a new one. Details in section 5.
5. Connect to the IntesisBox (details in section 5).
6. (optional) Configure the IntesisBox. Details in section 5.1
7. Check if there is communication in both BACnet and KNX buses (section 5)
8. The IntesisBox is ready to be used in your system.
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
®
IntesisBox
is a registered trademark of Intesis Software SL
User's Manual r18 eng
URL
http://www.intesis.com
Email
info@intesis.com
tel
+34 938047134
11 / 31
Advertisement
Table of Contents
Need help?
Do you have a question about the KNX TP-1 (EIB) and is the answer not in the manual?
Questions and answers