IntesisBox KNX TP-1 (EIB) User Manual page 10

®
IntesisBox BACnet/IP Server - KNX
•
EIS11 – 32bit Counter (32bit raw)
•
EIS13 – ASCII char (8bit raw)
•
EIS14 – 8bit Counter (8bit raw)
ETS3 or ETS4 software tools are not used to configure IntesisBox. Though, it's typical that
the choice of which KNX group addresses to use is restricted or defined by an ETS-based
project. If that's the case, the KNX installer/integrator needs to provide the set of group
addresses prior to doing the configuration of datapoints in LinkBoxBacnet.
Also, a dummy ETS application is provided by Intesis Software (section 6), which can be
imported into ETS. This application is nor downloadable into IntesisBox BACnet neither
usable for IntesisBox configuration. Rather, it poses as a means of having a device in the
ETS project representing the IntesisBox BACnet and its own datapoints/communication
objects, and to which group addresses are associated.
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
®
IntesisBox is a registered trademark of Intesis Software SL
User's Manual r18 eng
URL http://www.intesis.com
Email info@intesis.com
tel +34 938047134
10 / 31