6�12�4 Pads - Otto Bock MPS Instructions For Use Manual

Settings and use
Mounting the buildup
1� Drill holes at the proper positions in the footplate�
2� Attach the buildup to the footplate with the screws�
Using the buildup
1� Open the Velcro fastener�
2� Place the foot on the shoe holder�
3� Pull the straps firmly around the shoe crosswise and close the Velcro fastener fully�
6.12.4 Pads
INFORMATION
X Prior to mounting the pads, adjust the seat�
6.12.4.1 Footplate buildup padding
The footplate buildup can be equipped with padding�
Attaching the padding
1� Attach the self-adhesive Velcro strip to the bottom of the buildup�
2� Place the padding on the buildup and fasten the projecting ends to the Velcro strips�
6.12.4.2 Armrest pads
The armrests can be equipped with a pad�
Attaching the pad
1� With the open side, slide the pad over the armrest from the outside to the inside (see Fig� 54)�
6.12.4.3 Elbow pads
The positioning tray can be equipped with elbow pads�
Attaching the pad
1� Drill two holes respectively in the desired corners of the positioning tray (see Fig� 55)�
2� Screw the pads to the tray (see Fig� 56)�
24 | Ottobock
54
55 56
MPS