Adjusting The Seat Depth; Adjusting The Seat Width - Otto Bock MPS Instructions For Use Manual

6.4 Adjusting the seat depth
1� Remove the seat padding from the seat plate, including the hook and loop secured plastic seat insert�
2� Loosen the hex head screws on the right and left seat rail so that the seat rails slide into a longer or shorter
position�
3� Tighten the hex head screws to secure the seat rail at the desired seat depth�
4� Take the plastic seat insert that was removed and line it up with the front edge of the seat and press to secure
the hook and loop�
5� Put the padded seat cushion back onto the seat, tucking any remaining cushion depth between the gap of the
back shell and the seat�
6.5 Adjusting the seat width
1� Remove the seat padding from the seat plate (see Fig� 12)�
2� Open the rear hook-and-loop closure of the seat padding and carefully remove the foam pad (see Fig� 16)�
3� Adjust the width of the seat by removing the appropriate number of segmented foam strips from the right and
left lateral thigh supports�
4� Carefully insert the foam pad back into the cover and close it�
5� Position the entire seat padding back on the seat plate�
MPS
12
14
16
Settings and use
13
15
17
Ottobock | 13